TEKIN RX8 Gen3 BL Regler 1:8

• Funktionen: Vorwärts/Bremse/Rückwärts
• Eingangsspannung: 2S-6S LiPo / 4-16S NiMH/NiCD
• Motor Limit Brushless Mode:
• 2S Kein Limit
• 3S 4000kV
• 4S 3500kV
• 5S 2000kV
• 6S 1700kV
• Motor Limit Brushed Mode: Kein Limit
• Max. Belastbarkeit: 300A *
• Burst Belastbarkeit: 1000A *
• BEC: 6.0v / 7.4v @ 8A
• Abmessungen LxBxH: 55,8 x 38 x 35.5mm
• Gewicht: 76.5g

*Angabe des FET Herstellers

Programm Features:

• New HD Goldplated Solder Posts for Easy Soldering
• Multi Fin High Efficiency Heat Sink and Optional High RPM Cooling Fan
• Quick Tune™ One Touch Programming
• Adjustable Torque Control *
• Adjustable Throttle and Brake Frequencies *
• HD High Voltage Programmable BEC *
• HotWire™ Programming Port *
• Data Logging Capability *
• Sensor Checker
• OnBoard Temperature Indicator
• ESC Self  Diagnostics with Error Codes
• Fully Proportional Forward/Brake/Reverse
• Brushless and Brushed Motor Drive
• Sensored or Sensorless Operation
• LiPo Safe with Custom Voltage Cutoffs
• Sensor Plug for Precise Commutation
• HDAC: High Density Copper PCB's
• Ultrasmooth and Precise Throttle and Braking Control
• ON BOARD Quick Tune™ PROGRAMMABLE FEATURES
• DB Drag Brake (13 steps)
• BS Brake Strength (13 steps)
• LM Torque Limiter (7 steps)
• NW Neutral Width (13 steps)
• TP Timing Profiles 5 Preset 2 Custom*
• MT Motor Type
• Brushless Modes FWD Only / FWDREV / FWDREV Delay / FWDREV Delay REV Motor Direction
• Brushed Modes FWD Only / FWDREV / FWDREV Delay
• VC Voltage Cutoff : 2S, 3S, 4S, 5S, 6S, Custom*

Update ESC Firmware:

• Create, Save, Load and Share Custom ESC Profiles
• Drag Brake (0100 steps)
• Active Drag (ON/OFF)
• Brake Strength (0100 steps)
• Brake Minimum (030 steps)
• Active Braking (06 steps)
• RPM Brake (010 steps)
• Brake Frequency (750hz 12kHz)
• Throttle Minimum (030 steps)
• Throttle Frequency (2kHz 12kHz)
• Torque Limiter (010 steps)
• Reverse Speed (0100 steps)
• Reverse Delay (02seconds)
• Neutral Width (0100 steps)
• Push Control (0100 steps)
• Timing Profiles 5 Preset 2 Custom
• Dual Drive Mode
• Motor Type
• Brushless Modes FWD Only / FWDREV / FWDREV Delay / FWDREV Delay REV Motor Direction
• Brushed Modes FWD Only / FWDREV / FWDREV Delay
• Voltage Cutoff 2S, 3S, 4S, 5S, 6S, Custom Per Cell
• Fan ON/AUTO Modes

* HotWire Schnittstelle erforderlich